Edge-lighting Micro Switch User Manual

Browse online or download User Manual for Lighting Edge-lighting Micro Switch. Edge Lighting Micro Switch User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
SS-MSW
Installation Instructions for Micro Switch
904-SS-MSW-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2010 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
- Micro switch is normally closed momentary switch that is
rated for 12A, 125V AC.
IMPORTANT INFORMATION
A
A Typical Cabinet Installation Diagram
SS# 9
SS# 8
SS# 7
SS# 6
SS# 5
SW# 3
PS# 2
SW# 1
SS# 4
SS# 3
SS#2
SS# 1
SW# 2
PS# 1
Electronic Low
Voltage Dimmer
L
N-
+
SS#9
SS#8
120VAC
INPUT
L
N
SS#7
SS#6
SS#5
SS#1
SW#3
Electronic Low
Voltage Dimmer
PS#2
12VDC
OUTPUT
L
N
SW#1
SS#2
120VAC
INPUT
PS#1
-
+
12VDC
OUTPUT
SS#1: Tow kick soft strip.
SS#2 & SS#3: Bottom cabinet soft strips.
SS#4: Drawer soft strip.
SS#5: Under Cabinet soft strip.
SS#6, 7, & 8: Upper Cabinet glass door soft strips.
SS#9: Top of the Cabinet soft strip.
PS#1: PS-60-12VDC, PSB-60-12VDC, or TEB-60-12DC installed behind one of the drawer.
SW#1 & SW#2: Micro switches used in low voltage side to turn the SS#2, SS#3 & SS#4 on when the drawer or cabinet
doors are opened.
PS#2: TEB-60-12DC used with electronic low voltage dimmer to dim the SS#1, SS#5, SS#6, SS#7, SS#8, and SS#9.
SW#3: Micro switch is used in line voltage side to bypass the dimmer and turn to top cabinet soft strips to full power when
the cabinet doors are opened.
GLASS
DOOR
SS#3
SS#4
SW#2
Page view 0
1 2

Summary of Contents

Page 1 - Micro Switch

SS-MSWInstallation Instructions for Micro Switch904-SS-MSW-011718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613www.edgelighting.

Page 2 - Install the Micro Switch

2Install the Micro Switch1: Insert the soft strip wire connected to the "+ DC" side of the strip into the terminal connector and use the

Comments to this Manuals

No comments