Edge-lighting Vase User Manual download pdf

FJ-VASE1-_

Installation Instructions for Fast Jack Vase Round and Square

Install the Lamp

904-FJ-VASE-01

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

1: Push the LED lamp pins completely into the socket holes.

SAVE THESE INSTRUCTIONS!

IMPORTANT SAFETY INSTRUCTIONS

- Use this fixture indoors only.

- This product can be dimmed with a standard low-voltage

electronic dimmer.

- This product must be installed by a qualified electrician.

- Before beginning any electrical work, ensure that

power to the junction box is turned OFF.

FJ-VASE2-_

NOTE: Use MAXIMUM 3 Watt 12 VAC LED

Bi-pin lamp.

Adjust the Fixture Height

1: Cut the coaxial cable to the desired height (H) with a sharp

cutter. The overall fixture height is measured from the

bottom of the glass shade to the end of the coaxial cable.

M4 SET SCREW

M3 SET

SCREW

1.5MM ALLEN

WRENCH

2MM ALLEN

WRENCH

COAXIAL FIXTURE

CONNECTOR

2: Loosen the M4 set screw on base of the coaxial fixture

connector with the 2mm Allen wrench provided. Do not

remove this set screw.

3: Remove the M3 set screw on tip of the connector with the

1.5mm Allen wrench provided.

LED

BI-PIN

LAMP

SOCKET

1 2

Summary of Contents

Page 1 - Adjust the Fixture Height

FJ-VASE1-_AInstallation Instructions for Fast Jack Vase Round and SquareInstall the Lamp 1904-FJ-VASE-011718 W. Fullerton AveChicago, IL 60614Tel: 773

Page 2 - CIRCUIT

24: Feed the coaxial cable through the conical nipple and flared side of the strain relief tube. Slide the conical nipple and strain relief tu

Comments to this Manuals

No comments

Edge-lighting Vase User Manual

Browse online or download User Manual for Lighting Edge-lighting Vase. Edge Lighting Vase User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Vase