Edge-lighting Cirrus Channel Suspension, Tubular 1" Lens User Manual download pdf

SAVE THESE INSTRUCTIONS!

- This product is suitable for indoor locations.

- This instruction shows a typical installation.

IMPORTANT INFORMATION

Installation Instructions for Cirrus Channel Suspension T1, Tubular Lens

w/2SQ or 2RD Canopy

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

904-CCS-T1-04

CCS-T1-_

JOINER BRACKET

LENS

JOINER CHANNEL

MALE

CONNECTOR

FEMALE

CONNECTOR

CHANNEL

FRONT

VIEW

TOP OF CHANNEL

CHANNEL

1: Lift a section of the lens at the end of the channels where

the connectors are visible. Slide the channel over the joiner

bracket make sure that the male & female connectors mate

properly.

2: Push the lens back into the channel.

Connecting the Channel

NOTE: When using Edge Lighting Slim Profile Junction Box

(C-1RE-BOX), continue to "Install the Channel using the Junction

Box (C-1RE-JBOX)" on page 3.

NOTE: Omit this section if the channel is made out of a single

piece (120" or less).

NOTE: Prior to installation, multi-sectional Cirrus Channel should

be connected together for marking proper measurements.

NOTE: It is recommended more than one person assist in this

installation.

COAXIAL CABLE

STRAIN RELIEF

SLIDING POST

#4-40 SET SCREW

0.05" ALLEN

WRENCH

HOLD CABLE HERE

#4-40 SET SCREW

1: Loosen (DO NOT REMOVE) the #4-40 set screw on the

sliding post bushing and bed with a 0.05" Allen wrench.

2: Slide the strain relief tube out of the sliding post using a pair

of needle-nose pliers.

WARNING: To avoid damaging the coaxial cable electrical

connection, make sure that the end of the coaxial cable coming

out of the fixture is held with thumb before relocating sliding

posts.

CHANNEL CHANNEL

JOINER BRACKET

BACK

VIEW

3: Position the joiner bracket where the two channels meet.

Tighten four #6-32 set screws using the 1/16 Allen wrench.

1/16 ALLEN

WRENCH

#6-32 SET

SCREW

Adjusting Cable Position

1 2 3 4 5

Summary of Contents

Page 1 - Adjusting Cable Position

SAVE THESE INSTRUCTIONS!- This product is suitable for indoor locations.- This instruction shows a typical installation.IMPORTANT INFORMATIONInstallat

Page 2 - Install the Fixture

COAXIAL CABLESLIDING POST#4-40 SETSCREW0.05" ALLENWRENCHDCHANNEL333: Carefully move the sliding post to the predetermined location on channel

Page 3

3JSTANDOFFPOST TABAIRCRAFTCABLE88: Push the tab on standoff while feeding the aircraft cable coming from the channel into a standoff so that it ho

Page 4

417: Insert the coaxial cable into the coaxial connector until the wires of the center conductor are visible through the M3 set screw hole.NOTE:

Page 5 - Height Adjustments

521: Connect the black remote power supply wire to the black coaxial connector wire using a wire nut.22: Connect the black remote power supply w

Comments to this Manuals

No comments

Edge-lighting Cirrus Channel Suspension, Tubular 1" Lens User Manual

Browse online or download User Manual for Lighting Edge-lighting Cirrus Channel Suspension, Tubular 1" Lens. Edge Lighting Cirrus Channel Suspension, Tubular 1" Lens User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Cirrus Channel Suspension, Tubular 1" Lens