Edge-lighting 2x300W/12V Magnetic Remote Transformer User Manual download pdf

T-2X300-12

Installation Instructions for 2-Circuit 12V Single or Dual Feed Remote

Magnetic Transformers

904-T-2X300-12-02

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- Do not install this lighting system in a damp or wet

location.

- Do not conceal or extend bus bar conductor through

building wall.

- To reduce the risk of fire and burns, do not install this

lighting system where the insulated open bus bar

conductors can be shorted or contact any conductive

materials.

- To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

- Do not install fixture assemblies closer than six inches or

as specified in the fixture installation instruction to curtains

or similarly combustible materials.

- Turn the electrical power off before modifying the lighting

system in any way.

- The fixtures used with the Edge Lighting systems must be

identified for use with the corresponding Edge Lighting

systems.

- Minimum volume of the electrical box must be 6 cubic

inches (98 cubic centimeters).

- The system is "ETL" listed for USA and Canada only when

all the products used are supplied by Edge Lighting.

- RISK OF FIRE: This product must be installed by a

qualified electrician. Turn the power to the electrical box off

during installation. Read the Important safety instructions

before installation.

- This product is suitable only for indoor dry locations and

approved for the use at any height above the finished floor.

- This product may be dimmed only with a low voltage

magnetic dimmer. Using a dimmer other than specified may

work initially, but will eventually cause transformer failure

and void the warranty. The dimmer must be derated as

indicated by the dimmer manufacturer.

- A typical installation is shown. Specific installation must be

in accordance with the local electrical codes.

- TO REDUCE RISK OF FIRE, it is important to wire the

remote transformer for the system as described in this

installation instruction.

- Load each circuit of the remote transformer to MAXIMUM

300 Watt.

GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS

T-4X300-12

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Magnetic Transformers

T-2X300-12Installation Instructions for 2-Circuit 12V Single or Dual Feed Remote Magnetic Transformers 1904-T-2X300-12-021718 W. Fullerton AveChicago,

Page 2 - Switch 2 turns/off Circuit 2

2Installing the 120V wires to the T-2X300 TransformerA1CIRCUIT 1CIRCUIT 2SWITCH 1Switch 1 turns on/off both Circuits.CIRCUIT 2CIRCUIT 1SWITCH 1 SWITCH

Page 3 - LOW VOLTAGE WIRE SIZE CHART

HOT 1HOT 2COMDP2COM PP4P3P1T4T3T2T1COM T 5: Install the low voltage wires from the transformer to the electrical power feed box to which the po

Page 4 - Check the System

ETRANSFORMER COVERPHILLIPS SCREW4COMT T1 T2 T3 T4COMP P1 P2 P3 P4TRANSFORMER BRACKET4Check the System1: After installing the entire low voltage system

Page 5

5Installing the 120V wires to the T-4X300 TransformerF1F2Switch 1 turns on/off both Circuits 1&2.Switch 2 turns on/off both Circuits 3&4.SWITC

Page 6

6TRANSFORMER COVERPHILLIPS SCREW2COMT T1 T2 T3 T4COMP P1 P2 P3 P4TRANSFORMER BRACKET121G1: Use the transformer brackets to secure the transformers in

Page 7

7NOTE: 300 watt loads. Lengths are the distance from the transformer to the system power feed connector, or power feed canopy.The THHN wire sizes are

Page 8

P2COM TP4T1P3P2P1COM P12COM T10T2 T3 T411T1P3P1COM PT2 T3 T467891099910ICIRCUITBREAKERCIRCUIT BREAKERPHILLIPS SCREW1: After installing the entire low

Comments to this Manuals

No comments

Edge-lighting 2x300W/12V Magnetic Remote Transformer User Manual

Browse online or download User Manual for Lighting Edge-lighting 2x300W/12V Magnetic Remote Transformer. Edge Lighting 2x300W/12V Magnetic Remote Transformer User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting 2x300W/12V Magnetic Remote Transformer