Edge-lighting Frame User Manual download pdf (Page 2)

6: Remove a knock out to install the power line conduit.

7: Install the conduit and run the power line wires to the

housing.

8: Make sure that the housing is grounded in accordance with

local electrical codes.

9: Connect the white transformer wire to the neutral power

line wire with a wire nut.

10: Connect the black thermal protector wire to the hot power

line wire with a wire nut.

11: The black transformer wire is connected by default to the

other wire of the thermal protector.

STUD

TRANSFORMER

CONDUIT

Install Drywall, Trim & Lamp

3.2"

1: Mark 3.2" square(s) on drywall where the housing opening is

(are) located.

2: Cut out the marked square(s) and install the drywall.

3: After installing drywall and finishing it, connect each wire

coming out of the housing opening to one trim wire with a

wire nut.

4: Place all wires inside the housing and gently push the trim

into the housing opening by squeezing the springs clips.

DRYWALL

TRIM

COVER

THERMAL

PROTECTOR

HOUSING

SPRING CLIP

3.2"

10: Carefully pull the trim cover out of the housing to expose

the socket.

11: Push the lamp pins completely into the socket assembly

holes.

12: Replace and push the trim cover back into the trim housing

until it snaps into place.

CAUTION:

To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Use MAX 20 Watt Bi-Pin Halogen Lamp.

NOTE: Use only fingers and a soft cloth to install the lamps.

TRIM COVER

TRIM HOUSING

LAMP

SOCKET

1 2

Frame Halogen Kit 1

Comments to this Manuals

No comments

Edge-lighting Frame User Manual Page 2

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Frame