Edge-lighting Standoffs User Manual download pdf

SAVE THESE INSTRUCTIONS!

MS-1-_

- This product is ETL listed for indoor dry locations.

- The product is intended to be used with Edge Lighting

Monorail systems only.

- Use Monorail standoffs where the Monorail sections join

together and approximately every 3 feet throughout the

Monorail run.

Monorail 1" Rigid Standoff

Installation Instructions for

904-MS-1-02

IMPORTANT INFORMATION

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

Install the Standoff

1: Hold the Monorail section against the ceiling or use a plumb

bob to mark the standoff locations onto the ceiling (this may

require more than one person).

2: Tap the anchors onto the marked locations up to the

threaded portion with a hammer.

3: Screw the threaded portion of the anchors in with a Phillips

screwdriver.

ANCHOR

CEILING

4: Mount the standoffs onto the anchors with the #8 screws

provided. Make sure that the cut out portion of the

standoffs lines up with the Monorail.

#8 SCREW

1" STANDOFF

5: Slide Monorail into the cut out portion of the standoffs. Hold

the Monorail against the standoffs (

and tighten the M3 set screw on each

standoff with the 1.5mm Allen wrench.

this may require more

than one person)

MONORAIL

1.5MM ALLEN

WRENCH

M3 SET

SCREW

Install the Standoff 1

Summary of Contents

Page 1 - Install the Standoff

SAVE THESE INSTRUCTIONS!MS-1-_- This product is ETL listed for indoor dry locations.- The product is intended to be used with Edge Lighting Monorail

Comments to this Manuals

No comments

Edge-lighting Standoffs User Manual

Browse online or download User Manual for Lighting Edge-lighting Standoffs. Edge Lighting Standoffs User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Standoffs