Edge-lighting 2 Circuit Standoffs - Sloped Ceiling User Manual download pdf

M3 SET SCREW

1.5MM ALLEN

WRENCH

THREADED

POST

#8 SCREW

INTEGRATED

WASHER-NIPPLE

ANCHOR

M2S-SL-_

- This product is ETL listed for indoor dry locations.

- The product is intended to be used with Edge Lighting

Monorail 2 Circuit systems only.

- Use Monorail 2 Circuit standoffs where the Monorail 2

Circuit sections join together and approximately every 3

feet max throughout the Monorail run.

Monorail 2 Circuit Sloped Ceiling Standoffs

Installation Instructions for

904-M2S-SL-02

IMPORTANT INFORMATION

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

Install the Standoff Hardware

1: Hold the Monorail 2 circuit section against the ceiling or use

a plumb bob to mark the sloped standoff locations onto the

ceiling (this may require more than one person).

2: Tap the anchors onto the marked locations up to the

threaded portion with a hammer.

3: Screw the threaded portion of the anchors in with a Phillips

screwdriver.

ANCHOR

CEILING

4: Mount the integrated washer-nipple to the anchor with the

#8 screw provided.

5: Tighten the threaded post completely onto the integrated

washer-nipple.

1: Push the sloped standoff connector completely into the

threaded post and tighten the M3 set screw with the 1.5mm

Allen wrench.

SAVE THESE INSTRUCTIONS!

THREADED POST

Sloped Standoff Connector

Power Feed Canopies

Installation for Monorail 2 Circuit

SLOPED STANDOFF

CONNECTOR

1 2 3 4

Summary of Contents

Page 1 - Power Feed Canopies

CM3 SET SCREW1.5MM ALLEN WRENCHTHREADED POST1#8 SCREWINTEGRATEDWASHER-NIPPLEANCHOR4M2S-SL-_- This product is ETL listed for indoor dry locations.- The

Page 2 - Standoff

4M3 SET SCREW1.5MM ALLEN WRENCHJOINING POSTSLOPED STANDOFF CONNECTOR22X150 WattSloped Standoff Connector Surface TransformersInstallation for 1: See

Page 3

3Mounting the Monorail to Adjustable StandoffJ1THREADED POST1: Tighten the adjustable standoff threaded post completely onto the sloped connector

Page 4

45: Slightly loosen the M3 set screw on the conical nipple of each of the standoffs with the 1.5mm Allen wrench so that the conical nipples ca

Comments to this Manuals

No comments

Edge-lighting 2 Circuit Standoffs - Sloped Ceiling User Manual

Browse online or download User Manual for Lighting Edge-lighting 2 Circuit Standoffs - Sloped Ceiling. Edge Lighting 2 Circuit Standoffs - Sloped Ceiling User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting 2 Circuit Standoffs - Sloped Ceiling