Edge-lighting Zzz Lamp User Manual download pdf

FJ-ZL-_

Installation Instructions for Fast Jack Zzz Lamp Pendant

904-FJ-ZL-01

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- This product is ETL listed for indoor dry locations and

approved to be used at any height above the finished

floor.

IMPORTANT INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to

excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum

wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a

lamp shield provided by Edge Lighting and never place

flammable material close to the fixture.

- Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while

the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil

from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor

smoke when first turned on.

- Do not operate the luminaire with a missing or damaged

shield.

- Turn power off and allow to cool before replacing lamp.

Adjust the Fixture Height

1: Cut the coaxial cable to the desired height (H) with a sharp

cutter. The overall fixture height is measured from the

bottom of the glass shade to the end of the coaxial cable.

1 2 3 4

Summary of Contents

Page 1 - Fast Jack Zzz Lamp Pendant

FJ-ZL-_Installation Instructions for Fast Jack Zzz Lamp Pendant904-FJ-ZL-011718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613www

Page 2

22BM4 SET SCREWM3 SETSCREW1.5MM ALLENWRENCH2MM ALLENWRENCH23COAXIAL FIXTURE CONNECTOR2: Loosen the M4 set screw on base of the coaxial fixture con

Page 3 - CIRCUIT #2

312: Use fingers to tighten the Fast Jack fixture connector into the Fast Jack system connector (Monorail, Monorail 2 Circuit, or canopy c

Page 4 - Install the Lamp

CAUTION: To reduce risk of a burn or electrical shock during lamping, disconnect the power to the fixture.4Install the Lamp1: While holding the socket

Comments to this Manuals

No comments

Edge-lighting Zzz Lamp User Manual

Browse online or download User Manual for Lighting Edge-lighting Zzz Lamp. Edge Lighting Zzz Lamp User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Zzz Lamp