Edge-lighting Izar User Manual download pdf

FJ-IZAR-_

Installation Instructions for Izar Pendant

904-FJ-IZAR-01

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- This product is ETL listed for indoor dry locations and

approved to be used at any height above the finished

floor.

IMPORTANT INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to

excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum

wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a

lamp shield provided by Edge Lighting and never place

flammable material close to the fixture.

- Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while

the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil

from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor

smoke when first turned on.

- Do not operate the luminaire with a missing or damaged

shield.

- Turn power off and allow to cool before replacing lamp.

Adjust the Fixture Height

1: Feed the fixture coaxial cable through the glass shade

carefully lower the glass shade down to rest onto the socket.

COAXIAL CABLE

2: Cut the coaxial cable to the desired height (H) with a sharp

cutter. The overall fixture height is measured from the

bottom of the glass shade to the end of the coaxial cable.

GLASS SHADE

COAXIAL CABLE

SOCKET

1 2 3 4

Summary of Contents

Page 1 - Izar Pendant

FJ-IZAR-_Installation Instructions for Izar Pendant1904-FJ-IZAR-011718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613www.edgeligh

Page 2

2C3: Loosen the two M4 set screw on base of the coaxial fixture connector with the 2mm Allen wrench provided. Do not remove these set screws.4

Page 3 - CIRCUIT #2

3CIRCUIT #1CIRCUIT #212N12N10: Push the strain relief tube completely into the coaxial fixture connector. Make sure the slot on the strain relie

Page 4 - Install the Lamp

4ILAMPSOCKET21GLASS SHADE3Install the Lamp1: Lift glass shade up to expose the socket.2: Push the lamp pins completely into the socket holes.3: Carefu

Comments to this Manuals

No comments

Edge-lighting Izar User Manual

Browse online or download User Manual for Lighting Edge-lighting Izar. Edge Lighting Izar User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Izar