Edge-lighting Miniport LED Components User Manual download pdf

Installation Instructions for Miniport Round & Round Eye Lid LED

904-MPORT-12VAC-02

- This product is ETL listed for indoor wet locations.

- WARNING: Fixture must be installed in accordance with

National and Local Electrical codes.

- Load cannot exceed the total wattage of the LED power

supply rating.

- This fixture must be installed by a licensed electrician.

- Use UL listed type UF underground cable when no conduit

is used to power the fixture(s).

- For outdoor installation, use outdoor rated electrical

boxes (minimum 1.5" deep), conduit feedings, and wire

nuts. For indoor installation use octagon electrical boxes.

- This instruction shows a typical installation.

IMPORTANT SAFETY INFORMATION

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

MPORT-12VAC-_-SS

SAVE THESE INSTRUCTIONS!

IMPORTANT INFORMATION

- Miniports are only powered by a 12VAC LED transformer

and are dimmable with an Electronic Low Voltage

Dimmer.

Outdoor Installation Using a LED Single Power Supply (TE-60L-12)

OUTDOOR

ELECTRICAL BOX

CONDUIT GOING TO

ELECTRICAL PANEL

BUILDING WALL

1: Install an outdoor electrical box onto the wall or post next to

the building to fit the LED power supply (TE-60L-12) and to

branch the power to all in ground electrical boxes

2: Install conduit and run 120 volt power wires from the panel

to the outdoor box.

3: Install conduit(s) from the outdoor electrical box to all in

ground fixture outdoor electrical boxes.

4: Run proper wire sizes from branching electrical box to all

fixture electrical boxes using the "Wire Size Chart" on page 3.

GROUND

120VAC

2.97"

1.5"

1.47"

12VAC

NOTE:

maximum of 45 Mini Port fixtures.

The TE-60L-12 electronic LED power supply can power

5: Connect the white LED power supply wire to 120 volt neutral

power wire with a wire nut.

6: Connect the black LED power supply wire to 120 volt hot

power wire with a wire nut.

7: Connect one 12 volt power supply (red wire) in parallel to

one wire going to each fixture electrical box with wire nuts.

Connect the other 12 volt power supply wire in parallel to the

other wire going to each fixture electrical box with wire nuts.

(See wiring diagram on page 4).

8: Place the LED power supply and wire nut connection inside

the electrical box and mount the box cover.

120 VOLT

WIRES (INPUT)

12 VOLT

WIRES (OUTPUT)

1 2 3 4

Summary of Contents

Page 1 - IMPORTANT INFORMATION

Installation Instructions for Miniport Round & Round Eye Lid LED 904-MPORT-12VAC-02- This product is ETL listed for indoor wet locations.- WARNING

Page 2 - LED Power Supply (TE-60L-12)

2GROUNDDTRIM HOUSING#10-24 SCREW22 2 22: Align and secure each trim housing to the electrical box holes with the four #10-24 water sealant screws

Page 3 - Wiring the Trims

Indoor Trim Housing Installation2: Insert the provided plastic caps to all trim housing to prevent dust and debris from entering inside the box.3:

Page 4 - Indoor Installation without

4STAIRSLIGHT BEAMWALLKMINI PORT EYELID TRIM MUST BE ORIENTED IN THIS MANNER TO WORK PROPERLYNOTE: If installing eyelid Miniport to the walls next to s

Comments to this Manuals

No comments

Edge-lighting Miniport LED Components User Manual

Browse online or download User Manual for Lighting Edge-lighting Miniport LED Components. Edge Lighting Miniport LED Components User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting Miniport LED Components