Edge-lighting PSB-100W-24VDC-RGB, 100 Watt 24 Volt DC Power Supp User Manual download pdf (Page 2)

Using LED Power Supply with RGB Soft Strip & CDP or CTP

Controller

POWER SUPPLY

COVER

PHILLIPS SCREW

CASE

DVR-RGB-60

COVER

1: Loosen the six Phillips screws on front of the power supply to

remove the cover.

2: Carefully pull off the cover from the DVR-RGB-60 driver.

ELECTRICAL BOX

CONDUIT

CONTROLLER

POWER SUPPLY

DMX CABLE (BELDEN #9841)

3: Connect one end of a red wire to "VDC+" of the controller

terminal and the other end of the red wire to the "+24VDC"

of the power supply terminal.

4: Connect one end of a black wire to "Ground" of the controller

terminal and the other end to the "-24VDC" of the power

supply terminal.

5: Run the black and white line voltage wires coming from

the controller power supply to the power supply case.

6: Connect the white wire to "N" terminal of the controller

power supply.

7: Connect the black wire to "L" terminal of the controller

power supply.

8: Install conduits from controller, main panel (line voltage),

and soft strip to power supply.

9: Run proper DMX cable (Belden #9841 recommended)

with three data wires from controller to the power supply

box.

NOTE: Use a deep double gang boxes to fit the controller

and controller power supply (OT-20-120-240-245

recommended).

NOTE: Refer to the "Configuring DimWheel" & "Operating

DimWheel" on page 6 & 7 to properly operate the controller.

POWER SUPPLY

1 2 3 4 5 6

No comments

Edge-lighting PSB-100W-24VDC-RGB, 100 Watt 24 Volt DC Power Supp User Manual Page 2