Edge-lighting 300W/12V Electronic Remote Transformer User Manual download pdf

TE-300-12

Installation Instructions for

120 Volt Input to 12 Volt Single Feed Output

300 Watt Remote Electronic Transformer

904-TE-300-12-02

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- Do not install this lighting system in a damp or wet

location.

- Do not conceal or extend bus bar conductor through

building wall.

- To reduce the risk of fire and burns, do not install this

lighting system where the insulated open bus bar

conductors can be shorted or contact any conductive

materials.

- To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

- Do not install fixture assemblies closer than six inches or

as specified in the fixture installation instructions to

curtains or similarly combustible materials.

- Turn the electrical power off before modifying the lighting

system in any way.

- The fixtures used with the Edge Lighting systems must be

identified for use with the corresponding Edge Lighting

systems.

- Minimum volume of the electrical box must be 6 cubic

inches (98 cubic centimeters).

- The system is "ETL" listed for USA and Canada only when

all the products used are supplied by Edge Lighting.

- RISK OF FIRE: This product must be installed by a

qualified electrician. Turn the power to the electrical box off

during installation. Read the "Important Safety Instructions "

before installation.

- This product is suitable only for indoor dry locations and

approved for the use at any height above the finished floor.

- This product may be dimmed only with a low voltage

magnetic dimmer. Using a dimmer other than specified may

work initially, but will eventually cause transformer failure

and void the warranty. The dimmer must be derated as

indicated by the dimmer manufacturer.

- A typical installation is shown. Specific installation must be

in accordance with the local electrical codes.

- TO REDUCE RISK OF FIRE, it is important to wire the

remote transformer for the system as described in this

installation instruction.

- Load the circuit of the remote transformer to MAXIMUM

300 Watt.

GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS

1 2 3 4

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS!

TE-300-12Installation Instructions for 120 Volt Input to 12 Volt Single Feed Output300 Watt Remote Electronic Transformer 1904-TE-300-12-021718 W. Ful

Page 2

2Install the Remote Transformer1: the transformer to remove the transformer cover.Loosen and remove the two Phillips screws on the sides of ANOTE:

Page 3 - LOW VOLTAGE WIRE SIZE CHART

C38: Install a conduit from the transformer to the electrical box.9: For the best performance, use the "Low Voltage Wire Size Chart"

Page 4 - TRANSFORMER COVER

4D12: Connect the 120 volt power line wires at the panel.13: After operating the system for a few minutes, on the low voltage side, all electric

Comments to this Manuals

No comments

Edge-lighting 300W/12V Electronic Remote Transformer User Manual

Browse online or download User Manual for Lighting Edge-lighting 300W/12V Electronic Remote Transformer. Edge Lighting 300W/12V Electronic Remote Transformer User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Edge-lighting 300W/12V Electronic Remote Transformer